Try taking your kitchen cabinet refinishing job one step further by adding some molding to the fronts of your flat surface cabinets. You will create an interesting touch to your room without spending much more money than you will to do a simple refinish. Putting molding on your cabinets can be done easily.
The Basic Tasks
The first thing is to do the basic refinishing. Remove your cabinet doors and drawer-fronts and take off all the hardware. Scrub them with degreaser until they are thoroughly free of grease and contaminants. This will allow your paint to adhere to the surface. After the wood has dried, you can sand, clean, and paint. Put three or more very thin coats of paint, sanding and allowing drying between each coat. Always wipe away the sanding dust before you paint again.
When you have finished the task to this point, decide what kind of molding you want to have on your cabinet doors and cabinet drawer fronts. You can use thin, flat molding easily. kitchen cabinet refinishing Lattice molding and screen molding work fine, as do other kinds of flat molding. They are about 1/4 inch thick. You also need to consider the width you want. If you want a narrower molding, you can use screen molding, which is usually 3/4 inch wide. Lattice molding, at 1 1/8 to 1 3/4 inch wide is not as narrow.
Hold Up Sample Moldings Against the Cabinet Doors
In order to discover how you want to complete your refinishing project, take a couple of small pieces of each kind you are considering home with you. Hold them up against the doors and try to get an idea of how they would look in different patterns on the cabinet doors. Once you figure that out, you are ready to move on. Take measurements on your cabinet doors and drawer fronts to determine how much molding you would like to put on. Buy the molding.
After you have the molding, it is time to prime it, and then paint it. When you have done those things, you can begin to cut it up. Use a miter saw, a power miter saw if you have one available to you, to make the corners come out square. You have two choices of how to go on with your task at this point. You can cut all the molding pieces at once and then put them together on the cabinet doors and cabinet drawer fronts. The other option is to cut the molding for each cabinet drawer front or door, affix it, and then cut the next.
Use Yellow Wood Glue to Put the Molding Onto Your Cabinet
The best way to put the molding onto your cabinet surfaces is to use yellow wood glue. You will have to put a thin layer of glue all over the bottom of each piece you are attaching. Then, press it on and put some pressure on it for a half hour. You can do this by putting some weight on it or by putting some brads through it. Your cabinet refinishing will go better if you use the brads, because the molding might shift under a simple weight. Wipe away any glue that has oozed out, and let the pieces dry.
When you have put your cabinet doors and cabinet drawer fronts back in place, the next job is to add your own hand-picked hardware. When that is done, your kitchen cabinet refinishing job is complete.